Cork-filled PLA based filament EasyCork 2.85mm Light 50 gram 3D Printer Filament

Description

Unique features

• High cork filling
• Real cork feel, look and smell
• Very easy to print
• Warp-free printing
• Great thermal stability and filament flowing behaviour
• Perfect first- and inter-layer adhesion
• Can be printed at high printing speeds
• Lightweight and impact resistant

General printing guidelines

Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There are a lot of different type of printers, hot-ends and printer offsets that it is extremely difficult to give an overall one-size-fits-all setting.

Filament length

Nozzle cleaning

When printing with filled/composite filaments it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow in the dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.

Product export information

Compliance

This filament is compliant to below listed directives and regulations.

• RoHS directive 2011/65/EC
• REACH directive 1907/2006/EC

This declaration of conformity to directives and regulations is prepared according to our present standard of knowledge and may be amended if new cognitions are available and applies only for the above described products.